Diy Blackjack Table Plans
- Portable Blackjack Tables
- Diy Blackjack Table
- Build Your Own Blackjack Table
- Used Blackjack Tables For Sale
How to Build a Blackjack Table - Wood Working
STERLING MARTIN hat diesen Pin entdeckt. Entdecke (und sammle) deine eigenen Pins bei Pinterest. Blackjack Table Plans You should be starting with 2 sheets of 1/2' - 3/4' plywood, mdf, or particle board. Each sheet should be 3' x 6'. Before you start doing anything you should measure and mark off all of the cuts you are going to make. That’s a shame, because a good blackjack table can add a lot to the fun and excitement of a game. From basic tables that you can use in your own home when playing or practicing with your friends to the ornate tables found in major casinos around the world, a blackjack table is a major part of this great casino game. Elements of a Blackjack Table.
Blackjack Table Plans
Portable Blackjack Tables
You should be starting with 2 sheets of 1/2' - 3/4' plywood, mdf, or particle board. Each sheet should be 3' x 6'. before you start doing anything you should measure and mark off all of the cuts you are going to make. Since both sheets are identical for the first cut you can refer to figure 1-1 for both sheets when you start out. Measure 12' from the side and mark it off on each end of the wood. You then need to make an arc to connect both of those marks and the center of the wood on the far side. Once you make these cuts with a jig saw you will have 2 identical pieces of wood.
Diy Blackjack Table
One of these sheets (1) will be cut to make the top of the padded rail(figure 1-2), and the other (2) will be cut to make the blackjack playing surface and the bottom part of the padded arm rail (figure 1-3). To make the top part of the padded arm rest you will measure 4.5' all the way around the arced side of sheet 1 and draw a line. An easy way to do this is to set your square at the proper length with a pencil at the end and simply trace it around the edge marking along the way. The wood on the inside of the arc will not be used unless you want to attach it to the bottom of your completed table for added stability.
Sheet 2 can be made in the same faction but instead of a 4.5' rail you are only going to mark and cut off 2'. The outer part of the cut will be the bottom of the padded rail and the inner part will later be upholstered and used as the blackjack playing surface.
When these first cuts are done you should have 3 pieces of wood: A the playing surface, B the top of the padded rail, and C the bottom of the padded rail (figure 1-4). Before you upholster anything you should treat or seal all of this wood. It will make your blackjack table last longer and will prevent future warping.